The sm-8000a carrier tape molding machine has good performance. The mold installation, removal and adjustment method is simple and convenient.

The adjustment technician can adjust the heating, forming and punching molds in one step on the front of the molding machine.

The adjustment time is shortened within 1h, and the mold adjustment efficiency is significantly improved

Sm8000a molding machine is adjusted in the X. Y direction and adopts the sliding structure in the groove, with stable performance

The parallelism of the die can be adjusted in the Z direction, which is more conducive to uniform heating of the belt surface and cavity forming

The direct servo motor belt drawing device is adopted to ensure the accuracy. The feeding coil is controlled by induction motor, and the belt device can take in a super large reel with a diameter of more than 1m

Small volume, compact and reasonable overall structure

The system adopts humanized touch screen control, and the control panel is placed independently, which is convenient for technicians to operate, and fully considers man-machine engineering

technical parameter

Carrier tape forming width

12-88mm

Production speed

12-32MM (small size) (SM001 standard) / 240m / h

44-88mm (small size) (sm002 reinforced) / 210 M / h

Feed length

70-108mm

Belt pulling mechanism

Cylinder or motor drive

Carrier tape forming method

Compressed air (deep cavity plus push die mechanism)

Punching mechanism

Air pressure (punching die driven by cylinder)

Control system PLC (programmable controller)

Operation principle of man-machine interface touch screen control system

Precision mechanical adjustment of mobile platform x, y and Z

Equipment size

2650mm*780mm*1350mm(L*W*H)

pressure

6-8BAR

Power Supply

AC 220V 50-60Hz