Two reasons for carrier tape skipping :

one is that the tape jumps before loading the components,  the other is the components jump after tape weaving.

The skip is mainly due to the mismatch between the size of the carrier tape and the component, the size of A0 and K0 is too large, which has little to do with B0, or the hardness of the material does not meet the standard

In the latter case, K0 is too deep. As long as the die depth is changed to shallow, but at the same time, the more key and important factor can not be ignored is the use of inappropriate cover tape.

Therefore, it is easy to deform, affect the size, and it is difficult to control when braiding, resulting in material jumping, which can only change the size of the carrier tape or the hardness of the material.

When sealing electronic components, especially very micro components, the cover belt must be close to the carrier tape after sealing. If it cannot be close, there is a gap between the carrier tape and the cover tape