1. After production, the carrier tape is too loose or too tight

2. When the carrier tape arrives at the packaging machine table, the machine is not strengthened and fixed, resulting in large vibration amplitude of the carrier belt during operation

3. Incorrect placement method when packaging the machine on the belt

In order to solve the problem of bad winding of the carrier belt during installation, we should do the following

1. After production, the carrier tape shall be wound to an appropriate tightness, so that it can be operated better when packaging the machine

2. When placing the carrier belt on the packaging machine table, the machine needs to determine whether it is reinforced and fixed to reduce the range of carrier belt vibration during the operation of the machine

4.When packaging the machine on the carrier belt, it cannot be placed on a plane. The correct method should be to place the carrier belt upright

With the development of electronic components towards miniaturization, the traditional packaging technology can not better meet the packaging of most electronic components. Therefore, a new electronic component packaging technology has emerged. The packaging technology of load-bearing coil can not only meet the packaging requirements of most electronic parts, but also has advantages compared with blister and reduce labor cost. Load-bearing tape has become the main packaging mode in the electronic industry