According to the production specifications of the electronic industry and the 5S requirements of the workshop, during the production of the carrier belt in the workshop, the staff shall maintain the basic hygiene of the workshop, although cleaning the workshop every day and maintaining the environment is conducive to protecting the carrier belt from dust accumulation. However, in addition to the most basic practices, we should also pay attention to the following:

1. Clean the machine to prevent dust or sundries on the machine from being easily stained on the belt

2. During the production of the carrier belt, the leather will pass through the guide rail of the carrier belt forming machine, and the material belt may be scratched during the die groove of the punching die. Therefore, the ash will appear, especially when the punching die and the guide rails at both ends are not in a straight line, the black ash can be seen at the edge of the punching die groove. Therefore, pay attention to improving the die with burrs during machine adjustment

3. Before putting on the belt, pay attention to check whether there are sundries, burrs or dust on the lower leather,

Because sometimes the leather itself is of poor quality and this problem will occur if it is not handled properly

4. After the production of carrier tape, pay attention to whether it will be stained with ash stains under special circumstances.

5. The warehouse is generally sealed and packed, so it is not a big problem, but there are special circumstances that will also cause dust accumulation on the carrier belt

6. The household shall also do a good job in the protection of the carrier belt, such as the storage carrier belt or the sanitation of the packaging machine and workshop.

In addition, the embossed belt greatly reduces paper scraps, fluff and dust, and improves the stability of picking and mounting. The reduction of fluff and dust can not only avoid the defects of the welds of ultra-small components, but also prevent the blockage of the cavity and improve the picking efficiency. In the process of mounting, it can also effectively prevent the blockage of the suction nozzle, so as to reduce the frequent maintenance of the suction nozzle.

In the future, with the development trend of miniaturization of components, the carrier belt will also move towards precision and plastics.