一、 Carrier Tape drawing (according to EIA-481 specification)

1. Carrier Tape Drawings provided by the customer: judge whether the customer’s drawings will have problems in production

A. It is estimated that there will be problems such as difficulty in production. After communicating with the customer, modify the drawing for the customer’s confirmation.

B. convert the drawings without production problems into Beilu company format

2. The component drawing provided by the customer adds 0.3 as the carrier tape size on the basis of the size provided by the customer. In the actual design, it can be appropriately increased or reduced according to the component size.

3. The customer shall provide components, measure the size of components (used for limit or support in the carrier belt), and draw the carrier tape drawing according to the second principle

4. If there are components, measure whether there is any difference between the component size provided by the customer and the component drawing, and design the belt drawing according to the measured size

5. During the design process, the contact between the element welding leg and the carrier belt shall be avoided as far as possible

Reference table for selection of raw material thickness of carrier tape

Refer to the attached table for the selection of raw material thickness of carrier belt: in addition, the forming difficulty shall be considered and properly adjusted