PET carrier tape has good mechanical properties, impact strength is 3 ~ 5 times that of other films, and good folding resistance. Resistant to oil, fat, dilute acid, dilute alkali and most solvents. PET carrier tape has excellent high and low temperature resistance. It can be used for a long time in the temperature range of 120 ℃. It can withstand a high temperature of 150 ℃ and a low temperature of – 70 ℃ in a short time, and has little effect on its high and low temperature mechanical properties. —PET carrier tape

The permeability of gas and steam is low, and has excellent resistance to gas, water, oil and peculiar smell. High transparency, UV blocking, good gloss. It is non-toxic, tasteless, hygienic and safe. It can be directly used in food packaging.—PET carrier tape

The purpose of tape packaging machine is to package products, protect products, facilitate patch processing, improve production efficiency and save time and cost. In order to prolong the service life of the tape packaging machine, it is necessary to maintain it regularly. How to maintain it? Let’s take a look:

1. Check all parts regularly, at least once a month, and check whether the worm gear, worm, bolt, bearing and other moving parts on the lubrication block rotate flexibly and wear. If defects are found, they shall be repaired in time and shall not be used forcibly.

2. The machine shall be used in a dry and clean room, and shall not be used where acid and other corrosive gases circulate in the atmosphere.

3. After the machine is used or stopped, take out the drum, wash and brush off the remaining powder in the drum, and then install it correctly to prepare for next use.

4. When the drum moves back and forth during operation, please adjust the M10 screw on the front bearing seat to a proper position.

5. If the machine is out of use for a long time, the whole machine must be wiped clean. The smooth surface of machine parts must be coated with anti rust oil and covered with cloth.

The flat belt forming machine is suitable for belts above 12mm, especially for belts above 4mm; The forming stability of panel airborne belt is poor, P2 and F values are difficult to control, and it is difficult to form accurately. The roller belt carrier has a forming system composed of concave die and punch. The accuracy of punch can ensure the accuracy of belt carrier forming. The existing equipment can reach / -0.05 mm and the imported belt carrier forming machine can reach / -0.03 mm